Hi Ethan,
I did that. That was clear from other posts. What I found out that here in Germany the max tx power is only
available on some frequencies. So I set the channels maually. Now I have the max tx power for 2.4 GHz and 5 GHz.
Thx & Kind regards
------------------------------
Thomas
------------------------------
Original Message:
Sent: 08-24-2021 11:22 AM
From: Ethan Kozak
Subject: Access Points don't power at maximum
Hi YoDommo,
The power setting can be a little quirky - you need to set both dots on the slider to the level you want them at, otherwise they transmit variably.
So for a Max power setting, make sure both dogs of the slider are set to maximum.
Hope that makes sense, let us know if that worked or you need further assistance.
------------------------------
Ethan
Original Message:
Sent: 08-19-2021 03:20 PM
From: Thomas Hilbig
Subject: Access Points don't power at maximum
Hi there,
I'm new to Aruba Instant On. I have two access points (AP15 and AP22). It's most better than all of my repeater and access points from AVM in the past. Now I only need this two AP's instead of 6 from AVM.
In the Cloud Portal I set the transmit power for both 2.4GHz and 5GHz on my site to Max. When I checked the at the inventory the transmit power only shows for the AP15: 19.5dBm@2.4GHz / 23dBm@5GHz and for AP22: 20dBm@2.4GHz / 22.7dBm@5GHz. I thought that the max trasmit power were set to 30dBm for both. Why is the power below and how can I fix it?
The AP's have firmware version 2.3.1 installed.
Kind regards,
Thomas
------------------------------
Thomas
------------------------------