Instant On - Wired

Expand all | Collapse all

Help with local management webUI password

  • 1.  Help with local management webUI password

    Posted 23 days ago
    This is really strange. I set up a Instant On 1930 24 port switch and configure password for user admin.  It worked fine last week when I set it up.  But today I could not log in with the password.  Is there any way to do a password reset or recovery without performing a switch factory reset?

    Thanks,

    ------------------------------
    F L
    ------------------------------


  • 2.  RE: Help with local management webUI password

    Posted 23 days ago
    When setting your password if you just click the "apply" button changes are saving to the running-config file in RAM. To ensure you save them into flash you must click on the save icon in the upper right side of the page so changes will not be lost if the system reboots. You might try the default admin credentials again to see if that works. The last option is to factory reset the switch and start over.

    ------------------------------
    Greg Thiesen
    ------------------------------



  • 3.  RE: Help with local management webUI password

    Posted 22 days ago
    Hello,

    I have this issue too on 1930 24G. I saved the config each time but after few days, you can't login anymore. Default login/password absolutely don't work.
    I got this on 125 firmware version. I did'nt try with the fresh 133.

    Only things to do are reset and conf roll back. I would like to buy HPE1920S until a fixe release but I missed EOL...

    Thanks

    ------------------------------
    Fabien GOURAUD
    ------------------------------



  • 4.  RE: Help with local management webUI password

    Posted 22 days ago
    Please reach out to support and open a case so they can assist in troubleshooting your password issues.
    https://community.arubainstanton.com/support/contact-support

    ------------------------------
    Greg Thiesen
    ------------------------------