Hi,
I've just started configuring my new switch, in local mode. I'd reset to factory defaults, set up a few VLANs, set a static management IP address, and changed the management VLAN. With that all working running firmware 1.0.3.0 (131.78206), I uploaded (via HTTP) firmware1.0.5.0_139. The only option was to upload to "backup image" which was confusing, but I went ahead. At the end of the upload the switch asked to reboot, I said fine. When the switch came back up, I found I'd lost connectivity. Then I discovered that the switch had reset itself to factory settings, all my previous configuration had been lost. As the switch is not yet in my network this is not the disaster it would be if it happened after installation.
My question is: Is it to be expected that 1930 resets to factory default settings on local firmware upgrade?
Thanks for your help,
Frank
------------------------------
Frank Myhr
------------------------------