Hi Leandro,
I made a test, using a NaviTEK network tester for which I configured the RJ45 port as follows:
Auto Negotiate: Disabled
Speed: 10 Mbps
Mode: Full Duplex
MDI: Auto
I then patched the tester into the 1930 switch and run the NETWORK test; the results are below. As you can see in the screenshots below, even if I manually configured the RJ45 port, the switch set the line rate to 100 Mbps, and all the tests passed.
I hope this helps.
------------------------------
Valentin Voica
------------------------------
Original Message:
Sent: 07-12-2021 12:56 PM
From: Leandro Melo
Subject: Supported Standard on 1930
Hello Team,
I Need to know if the familiy 1930 support the 802.3 i Standard, I found the user guide but this features has not been covered by this manual.
I believe that we can't find any problem...
Thanks a lot!
------------------------------
Leandro Melo
ACMP and studying!
------------------------------