Hello everyone,
I have aruba 1930 sw and I need to connect it to a juniper sw ex3300. I need to configure multiple vlans on both sw. On juniper side things are very clear. But I have been struggling with 1930 configuration. On 1930 I have some ports in vlan #2 and some ports in #3 (both are untagged). On the uplink (1930 side) I have both vlans tagged. One of the vlans is working while the other is not reachable. The configuration at the Juniper side as follows ( trunk port, member of both vlans).
Any help with this is appreciated.
Thanks a lot
------------------------------
Alaa Smarneh
------------------------------