Instant On - Wireless

 View Only

  • 1.  AP11D setup as a router mode but i need to change that to normal mode how ?

    Posted 06-03-2022 01:47 PM
    Hi,

    I setup Aruba AP11D as a router mode, and as DHCP server with no issues.
    But i need to change the setup so i can use that AP11D as AP only and VLAN and DHCP from the router how can i do that ?
    I could not find a away to reserves the configuration 

    Any help please

    ------------------------------
    Hani Abuelkhair
    ------------------------------


  • 2.  RE: AP11D setup as a router mode but i need to change that to normal mode how ?

    Posted 06-03-2022 03:16 PM
    The only way is to delete the existing site, hard reset the AP and create a new site. While creating a new site, choose the 1st option under " set up your connectivity".
    The factory reset the AP11D

    Not sure if this is the only way to do it but i did it and all good now

    Thanks

    ------------------------------
    Hani Abuelkhair
    ------------------------------

    Original Message


  • 3.  RE: AP11D setup as a router mode but i need to change that to normal mode how ?

    Employee
    Posted 06-08-2022 03:03 PM

    To change AP mode from router to AP only mode follow the steps below.

    1. Delete the site where AP is already onboarded which will reset the AP to factory default state without any configs.
    2. Create a new site and while creating a new site choose the 1st option as highlighted which will onboard AP in normal AP mode.




    ------------------------------
    Aruba Instant On Communications
    ------------------------------

    Original Message