Hi Guys....i have some question.
on existing network has some vlan for device client (vlan 10 for employee and vlan 20 for Guest)and vlan management device network (vlan 30 for management device network)
what i must doing on the switch port?1. setup trunk all with native vlan 30, then enable "assign a VLAN to your network" and then fill vlan ID 10?2. or just only setup access mode vlan 30, then enable "assign a VLAN to your network" and then fill vlan ID 10?
In Instant On parlance, you would create a Network for each VLAN you need. By default, all VLANs will be made available on all ports of the switches (or AP11D ports) on site. You can go in the Inventory section and change the behavior for each port.
Hope this helps.