Instant On - Wireless

  • 1.  Aruba Instant ON - Mesh (Primary Controllers)

    Posted 13 days ago
    Hello Aruba team,

    Is it possible to have multiple primary controllers in the same Mesh network? In an example scenario, I have two floors to accommodate. 
    Using full wireless Mesh, I wanted to cover each floor with its primary to avoid latency or interference and excess hops. 

    1st Floor = 3 units of Instant ON AP22 
    1 Parent Node = 2 Child Nodes

    2nd Floor = 6 units of Instant ON AP22
    1 Parent Node =  5 Child Nodes

    Is this possible or any recommendations you may add? 

    Best regards,







    ------------------------------
    Justin
    ------------------------------


  • 2.  RE: Aruba Instant ON - Mesh (Primary Controllers)

    Posted 12 days ago

    Hi Justin,

    A good question - I'm following this out of curiosity. Mesh is a bad idea in general though. 

    If lowered latency and interference are important, mesh is probably not the solution. 

    How well mesh will work will be dependent on how many clients you'll have connected to each node, the type of traffic, and the volume of traffic. If you're using mission critical low latency applications, scrap mesh. If you plan on 20-40 client devices per AP, scrap mesh. 

    Two mesh nodes for every one parent device is about as high as I'd want to go in a busy environment. The parent device only has so much airtime to distribute. 

    I am curious to know the official answer to your question though! 



    ------------------------------
    Ethan
    ------------------------------



  • 3.  RE: Aruba Instant ON - Mesh (Primary Controllers)

    Posted 12 days ago
    Most mesh systems you can put in as many wired APs that you want and then augment them with mesh nodes where you can't get wires but need better coverage but I believe most are limited to a max of two mesh hops to get to any wired AP.  I couldn't even find a decent answer on Eero APs and all their diagrams just show a single hop.  I've never used any hoppers cuz I can usually add wires.  At least so far I've never had a need.


  • 4.  RE: Aruba Instant ON - Mesh (Primary Controllers)

    Posted 11 days ago
    Hey Justin,

    Thank you for reaching out to us here. I'm checking with my team to confirm what recommendations would be good for this situation.

    ------------------------------
    Aruba Instant On Communications
    ------------------------------